Set the Tunnel Protocol to TCP or UDP.For TCP/UDP protocol you may enter one of the following port number 53, 80, 443 or 1194. Enter VPN Server Address to Server IP/Name.Click on „Security” then „Firewall” and set „SPI Firewall” to „Disable” and click „Apply settings” button to save.ħ. Set „Start OpenVPN Client” to „Enable”.

Uncheck all three checkboxes for „Use DNSMasq for DHCP”, „Use DNSMasq for DNS” and „DHCP-Authoritative” and enter 208.67.222.222 and 208.67.220.220, 8.8.8.8 and 8.8.4.4 into „Static DNS 1”, „Static DNS 2”, „Static DNS 3”, „Static DNS 4” textbox as seen on the screenshot. Builds or versions other than v24-sp2 (12/22/14) may have bugs preventing OpenVPN connections.Ģ. Software version that has been tested to work on VPN servers is DD-WRT newer build. Open a web browser, and load the following address: Note, set your network connection to obtain IP address automatically if you connect to your router via Ethernet.Ĭheck your DD-WRT firmware. Connect to the DD-WRT router using either an Ethernet cable or by joining the wireless network ‘dd-wrt’. Note! If you choose to use your DD-WRT router as an access point, you may want to disable the Wireless network in Vilfo.1. To make future changes in DD-WRT you will need to do so using the IP address assigned to your DD-WRT router by Vilfo. Under Device IP address, enter the IP address of your DD-WRT router that you wrote down previously. Locate your DD-WRT router in the list of devicesĬlick on your DD-WRT router in the list of devices In order to be able to access the DD-WRT user interface after the change has been made, you may need to change the IP address of the DD-WRT router to match that of Vilfo. Step 2: Changing the DD-WRT router IP in Vilfo

Under Network Address Server Settings (DHCP), enter the following settings.Ĭonnect a network cable between the LAN port on Vilfo to the WAN port on your DD-WRT router Under Network Setup, enable the option Assign WAN Port to Switch By default Vilfo uses 255.255.0.0, if the subnet mask differs from the one shown in Vilfo, enter the new one to match the one Vilfo use Subnet Mask: Check that the subnet mask is the same one Vilfo use. Write down the IP-address shown here (By default, 192.168.1.1) Local IP Address: Verify that the IP address entered here is in the same subnet that Vilfo use. Under Network setup, check the following options: Under WAN Connection Type ➝ Connection Type, select Disabled

Update for dd wrt v24 sp2